Clothes still wet
Wet clothes come from one of two places: a washer that couldn’t spin them out, or a dryer that didn’t finish the job.
Soaking wet out of the washer
A washer spins most of the water out at the end. When it can’t, the cause is usually one of these.
Too much soap. Foam fills the drum, and the washer stops instead of spinning. Next time, use 2 tablespoons. See Soap.
A lopsided load. One heavy thing, or too few things, can’t balance. Wash at least two five-gallon buckets’ worth, with large and small things together. See Loading.
Too full. More than three buckets’ worth can’t tumble or spin well.
What to do now:
If the washer stopped with a code on the display, wait 30 minutes, then send me a photo of the display.
If it finished but the clothes are dripping, spread them evenly in the drum, or take some out, and wash again with no soap.
Don’t put dripping clothes in a dryer. They take far longer to dry and cost you more.
Too much soap and unbalanced loads aren’t refundable. Both are explained under Common mistakes.
Still damp out of the dryer
Clean the lint trap and dry again.
Don’t overfill. Split a big load in two.
Dry heavy things, like towels and jeans, apart from light things.
Use a hotter setting if the care label allows it.
Add time while the dryer is running. Every cycle ends with a few minutes of cool air, so a very short top-up dries little.
Tell me when
loads take longer than usual to dry. The vent may be blocked.
the drum turns but the clothes stay cold after a full cycle. The dryer may not be heating.
a washer leaves load after load soaking wet, even with little soap.
Text the number posted in your laundry room, email info@stuffthatspins.net, or use the contact form. I reply within 1 to 3 business days.